Specifications

10 Getting Started
Note:
• Charge the battery to its full capacity until the charge light turns off.
• Be sure to slide the battery replacement switch to the “ ” position before
charging.
• If a charging error occurs, the charge light will blink. Make sure that the AC
power cord and the AC adapter are connected correctly, remove and reinsert
the battery, then perform steps 1 to 3 above again. If the error persists, there
is something wrong with the battery, Zaurus, etc. Contact your local SHARP
dealer for repair.
• The AC power cord plug may differ in some countries.
Step 2: Pulling out the stylus
This unit comes equipped with a stylus to
select items and enter various kinds of
information, etc.
Pull out the stylus as shown. To replace it,
insert it so that the protruding part of the
stylus locks into place.
Touch the button displayed on the screen
one time to open, select an item, etc.