Specifications

Getting Started 11
Step 3: Initial settings
Open the Display protection cover (see page 29) and carry out the initial setup of the
Zaurus after completing the battery charge.
Turning the unit on
1. Press to turn the power on.
The Welcome screen will appear after a few minutes.
Then, follow the next steps to complete the initial settings.
Note:
• If the power will not turn on after charging the battery, disconnect the AC
adapter and remove the battery. After approximately 10 seconds, replace the
battery, perform the reset operation and then recharge the battery again (See
page 85 and 90).
• If the Welcome screen does not appear, try to Format the Zaurus (See page
89).
Also make sure that the battery replacement switch is set to “ ” and the
battery is inserted correctly.
• During the initial settings, if you do not operate the Zaurus, the power will
automatically turn off after 8 hours (with AC adapter connected) or 10 minutes
(without AC adapter). Turn the power on, then proceed to the next step.
• If the battery level is low, the power will not turn on even if you attach the AC
adapter. Charge the battery to its full capacity.
Adjusting the touch panel
1. On the Welcome screen, tap anywhere on the screen.
The Calibration screen will appear.
2. Tap the cross hairs firmly one by one.
When you have completed adjustment of the touch panel, the Set System Time
screen will appear.
Then, follow the next step.