Specifications

80 How to Install Applications on Your Zaurus
How to Install Applications
on Your Zaurus
This section provides the procedures for installing software from the accompanying
CD-ROM onto the Zaurus.
Step1: Transfer the application installation file from the CD-ROM to the Zaurus.
Insert the CD-ROM into your CD-ROM drive.
The procedure for transferring the application installation file to the
internal Flash memory of the Zaurus will be explained. (The software can
also be transferred to a memory card.)
Step2: The software installation process will be executed on the Zaurus.
The procedure for installing software into the Zaurus Internal Flash
memory will be explained. (The software can also be installed onto a
memory card.)
Step 1: Copying the Software to the Zaurus
1. Check that the Zaurus File Transfer application has been installed correctly
according to the instructions that start on page 15.
2. If the Zaurus and PC are not already connected, connect them using the
Docking Station following the steps on page 32 (“Connecting the Zaurus to your
PC”).
Note:
• If you have set or changed the Security passcode on the Zaurus or changed
the method of connection in the “PC Link” application on the Zaurus, also set
or change the settings on the “Zaurus Manager” screen in your PC. (See
“Security” in the Operation Manual and “Zaurus Manager Setting” in the
operation manual for Zaurus File Transfer application, etc.)
• When communicating with the PC, do not perform any operations on the
Zaurus, do not turn off the power, do not remove it from the Docking Station,
and do not disconnect the cable from the PC.
• When communicating with the PC, the AC adapter must be connected.
3. Turn on the power for the Zaurus. If the power is already on, turn it off, wait
approximately 30 seconds, then turn the power on again.