Manual

BEFORE OPERATING
Before operating your new Microwave Drawer make sure you
read and understand this operation manual completely.
• Before the Microwave Drawer can be used, follow these
steps:
1 Plug in the Microwave Drawer. _ _ _
will
appear.
2 Touch the STOP/CLEAR pad. _ will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/CLOCK pad and number [2].
2 Touch number pads for correct time of day and touch
TIMER/CLOCK pad again.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, _ will appear in the display. Touch the
STOP/CLEAR pad and re-enter the time.
* If the electrical power supply to your Microwave Drawer
should be interrupted, the display will intermittently show
_ _ after the power is reinstated. If
this occurs during cooking, the program will be erased. The
time of day will also be erased. Simply touch STOP/CLEAR
pad and reset the clock for the correct time of day.
Note:
TIMER
1 Touch TIMER/CLOCK pad and number [_.
2 Enter time.
3 Touch TIMER/CLOCK pad again.
To cancel timer, touch STOP/CLEAR.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Microwave Drawer temporarily during timed
cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
OPEN OR CLOSE MICROWAVE DRAWER
Always press the OPEN/CLOSE pad on the control panel to
open or close the microwave. Do not push or pull the drawer
microwave by hand, except in the case of emergency, such as
a power failure. If necessary, push or pull slowly.
* The Microwave Drawer can be programmed with the
drawer open except for START/+30 SEC.
10