Use and Care Manual

10
BEFORE OPERATING
Before operating your new Microwave Drawer make sure
you read and understand this operation manual completely.
• Before the Microwave Drawer can be used, follow these
steps:
1 Plug in the Microwave Drawer.
ENJOY YOUR MICRO-
WAVE TOUCH CLEAR
will appear.
2 Touch the STOP/CLEAR pad.
:
will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/SETTINGS pad twice. The display shows
TO SET CLOCK ENTER TIME
.
2 Touch number pads for correct time of day and touch
START/+30 SEC pad.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time,
ERROR
will appear in the display. Touch the
STOP/CLEAR pad and re-enter the time.
• If the electrical power supply to your Microwave Drawer
should be interrupted, the display will intermittently show
ENJOY YOUR MICRO- WAVE TOUCH CLEAR
after
the power is reinstated. If this occurs during cooking, the
program will be erased. The time of day will also be erased.
Simply touch STOP/CLEAR pad and reset the clock for the
correct time of day.
Note:
• The Microwave Drawer can be programmed with the
drawer open except for START/+30 SEC.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Microwave Drawer temporarily during timed
cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
OPEN OR CLOSE MICROWAVE DRAWER
Press the OPEN/CLOSE pad on the control panel or wave
twice on top left side of the drawer to open the microwave.
The Easy Wave only works to open the microwave, not close.
The Microwave Drawer also can be closed by gently pushing
on the drawer. Do not pull the drawer by hand, except in the
case of emergency, such as a power failure. If necessary,
push or pull slowly.
EASY WAVE OPEN ON/OFF
Easy Wave Open is default OFF when plugged in. The
function must activate from within the Timer/Settings Menu.
The blue light on the center of the panel will illuminate once
Easy Wave Open has been activated. When Control Lock is
activated, the Easy Wave Open function is off.
To use the Easy Wave Open functions, simply wave your hand
in front of the sensor twice in consecutive motions. This can
be either up and down or side to side motions.
EASY WAVE OPEN ON
1 Touch TIMER/SETTINGS pad 8 times. The display shows
EASY WAVE OVEN ON ? TOUCH START
.
2 Touch START/+30 SEC pad. The display shows
EASY WAVE OVEN ON
.
3 When activated, a blue LED indicator is illuminated on top
to indicate that the function is on.
EASY WAVE OPEN OFF
1 Touch TIMER/SETTINGS pad 8 times. The display shows
EASY WAVE OVEN OFF ? TOUCH START
.
2 Touch START/+30 SEC pad. The display shows
EASY WAVE OVEN OFF
.