SKCD24U0GS Installation Guide

5
INSTALLATION INSTRUCTIONS
6. Install the wooden cleats. Align the bottom of the cleat
to the measurement from Step 5. The pedestal can be
installed ush or standardwith the face of the cabinet.
Depending on the preference, the depth of the cleat
position should be adjusted as such. See Figure 6.
Position each cleat and mark the holes on the cabinet.
Pre-drill each hole in the cabinet using a
1
/16" (1.6 mm)
drill bit. Attach both cleats using the 4 mounting cleat
screws. See Figure 7.
MOUNTING CLEAT SCREWS
FIGURE 6
X Y
STANDARD MOUNT
CLEAT
CLEAT
FLUSH MOUNT
CABINET FACECABINET FACE
UTC DRAWER FACE
UTC DRAWER FACE
*NOTE: WHEN USING CONTRACTOR CABINET FACES,
ADD OR SUBTRACT ADDITIONAL DIMENSION.
SUPPLIED DRAWER FACES ARE 1
3
/16"
FIGURE 7
7. Slide the unit into the opening. Plug oven into the wall
receptacle prior to pushing the unit all the way in. See
Figure 8. The mounting angles of the oven should rest
against the installed wooden cleats.
NOTE:
• To aid in sliding the unit into the space, open the
bottom drawer and use middle frame to push into
place. In addition, there are built-in handles on each
side of the pedestal that can assist in the movement of
the unit. Tuck cord behind the oven before pushing the
assembled unit in.
• If the chosen height of the installation presents a gap
between the counter top and the unit, attach cabinet
llerstripasnotedinFigure8.Cabinetllerstripcanbe
purchased wherever cabinets are sold.
*NOTE: ATTACH CABINET FILLER STRIP IF NEEDED
LEVEL UNIT TO DESIRED HEIGHT
FIGURE 8