Installation Guide

ELECTRICAL OUTLET

The electrical requirements are a 120 volt 60 Hz, AC only, 15

amp. or more protected electrical supply. It is recommended that

a separate circuit serving only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must

be plugged into a wall receptacle that is properly installed and

grounded. Should you only have a 2-prong outlet, have a qualied

electrician install a correct wall receptacle.

* Install the oven in a cabinet with the proper 3-prong outlet or in a

cabinet adjacent to a proper 3-prong outlet if the provided power

supply cord can reach the outlet. Do not use an extension cord.

Note: Always check electrical codes for requirements. If you

have any questions about the grounding or electrical instructions,

consult a qualied electrician or service person.

GROUNDING INSTRUCTIONS

This appliance must be grounded. The oven is equipped with a

3-prong plug which includes a grounding pin. It must be plugged

into a wall receptacle that is properly installed and grounded in

accordance with the National Electrical Code and local codes

and ordinances. In the event of an electrical short circuit,

grounding reduces risk of electric shock by providing an escape

wire for the electric current.

Improper use of the grounding plug can result

in a risk of electric shock. Do not use an extension cord. If the

power supply cord is too short, have a qualied electrician or

serviceperson install an outlet near the appliance.

BEFORE YOU CALL FOR SERVICE

Read the BEFORE YOU CALL and operating instruction sections

in your Operation Manual. It may save you time and expense. The

list includes common occurrences that are not the result of defec-

tive workmanship or materials in this Smart Combi Steam Oven.

Refer to the warranty in your Operation Manual for Sharp’s

toll-free service number and address. Please call or write if you

have inquiries about your Smart Combi Steam Oven product and/

or need to order parts.

MODEL AND SERIAL NUMBER LOCATION

The model number and serial number are printed on the

nameplate. To access the nameplate, open the drip tray door and

remove the drip tray. The nameplate is located to the left of the

reservoir.

Nameplate Location

CARE, CLEANING AND MAINTENANCE

Refer to the Operation Manual for cleaning instructions.