Installation Guide

2
PARTS
Before installing, verify all parts are included. If any parts are
damaged and/or missing, contact your dealer or a Sharp Authorized
Servicer.
PART INCLUDED
PARTS QUANTITY
Anti-Tip Bracket 1 bracket, 2 screws
Oven Probe 1
Flat Rack 1 or 2 (depending on the model)
Gliding Rack (some models) 1
Optional Rear Trim Kit 1 trim, 2 screws
MATERIALS NEEDED
The utility connection and house structure at each home may be
different, so the specic parts required for connection to the house
are not included with the product. The parts identied below are
or may be required to complete the installation. Always use new
components and never use an old part for new range installation.
GETWIREDUSA FX359
14-50P
POWER CORD STRAIN RELIEF FOR
POWER CORD
(SUPPLIED WITH CORD KIT)
5
/16" OD SLEEVE ANCHOR (WITH
1
/4" BOLT) - 2 PCS
(FOR CONCRETE FLOORS ONLY)
SUPPLIED BY INSTALLER
(NOT INCLUDED)
The utility connection and house structure of each home varies,
so specic parts required for connection are not included with
the product and must be purchased separately. Always use new
components; never use an old part for a new range installation.
TOOLS NEEDED
CUT RESISTANT GLOVES, SAFETY GLASSES OR GOGGLES, STEEL-TOED SHOES
(FOR YOUR SAFETY AND PROTECTION)
DROP CLOTH OR CARDBOARD
(OPTIONAL - TO PROTECT FLOOR)
DRILL AND
1
/8" DRILL BIT (FOR ANTI-
TIP BRACKET INSTALLATION)
TAPE MEASURE
(TO CONFIRM INSTALLATION SPACE)
PHILLIPS SCREWDRIVER (TO ACCESS
SERVICEABLE COVERS)
ADJUSTABLE GROOVE-JOINT OR
GOOSENECK PLIERS
(FOR LEVELING PRODUCT)
LEVEL
(FOR LEVELING PRODUCT)
NUT DRIVER
(FOR ELECTRICAL CONNECTIONS AND
ANTI-TIP BRACKET INSTALLATION)
PENCIL AND RULER
(FOR ANTI-TIP BRACKET
INSTALLATION)
208/240VAC OUTLET TESTER MASONRY DRILL BIT
(FOR ANTI-TIP BRACKET
INSTALLATION - CONCRETE
FLOORS ONLY)