Installation Guide

4
CUTOUT DIMENSIONS
SLIDE-IN CUTOUT
Width 30"
Depth 23
11
/16"
FREESTANDING CUTOUT
Width 30"
Depth 25"
30"
6
"
36"
30"
30"
18"
24" lower cabinet depth
13"
overhead
cabinet
depth
FIGURE 2
NOTES:
• FOR ISLAND INSTALLATIONS, MAINTAIN 6'' MINIMUM FROM THE CUTOUT TO
THE BACK AND SIDE EDGES OF COUNTERTOP.
• OVERHEAD CABINETRY MUST BE AT LEAST 30" (76.2CM) ABOVE THE
COOKTOP SURFACE AND NOT EXTEND MORE THAN 13" (33CM) OVER THE
COOKTOP SURFACE.
• MAINTAIN 0" CLEARANCE AT REAR AND SIDES OF THE RANGE.
30"
23
11
/16 "
25"
7"
electric supply
area
FIGURE 3
NOTE:
• CUTOUT FOR INSTALLATION WITH USE OF REAR TRIM KIT IS 25" DEEP.
• CUTOUT FOR SLIDE-IN INSTALLATION WITH NO REAR TRIM REQUIRED IS
23
11
/16" DEEP.
• HATCHED FACES OF COUNTERTOPS SHOULD BE FLAT AND LEVELED.
INSTALLATION PROCEDURE
CAUTION
LACERATION, FOREIGN OBJECT,
CRUSH HAZARD
• When installing, moving or servicing any appliance, wear proper
protective equipment, including cut resistant gloves, steel-toed
shoes and safety glasses.
IMPORTANT Failure to remove packaging materials could result
in damage to the appliance.
1 Remove all tape and packaging materials. Check for lm on
stainless steel parts, padding/spacers on and around door and
face of oven, cardboard and plastic on and around racks, inside
storage drawer, etc.
Do not use sharp instruments, rubbing alcohol, ammable
uids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your range.
2 Inventory all loose parts against the PARTS INCLUDED chart
on page 2.
Check for shipping damage and/or missing parts. Report any
damaged and/or missing parts to your local retailer.
3 To reduce the weight of the range while being moved, adjusted,
and installed, set aside cooktop grates, cooktop burners, oven
racks and any other accessories until the unit is installed and
ready for use.
During installation, service and leveling, it is recommended to
remove the oven door and drawer. See the Operation Manual
for instructions on removing the oven door and drawer.
4 Adjust and level the range height by rotating the leveling legs
so the overhang rests on the countertop surface with no gap.
ANTI-TIP BRACKET
WARNING
TIP OVER HAZARD
• A child or adult can tip the range and be injured or killed. Verify
the anti-tip device has been properly installed and engaged per
installation instructions. Ensure the anti-tip device is re-engaged
when the range is moved.
• Do not operate the range without the anti-tip device in place and
engaged. Failure to do so can result in death or serious burns to
children or adults. Do not remove the leveling legs. Doing so
will prevent the range from being secured by the anti-tip device.
To reduce the risk of tipping of the range, the range must be secured
to the oor by the properly installed Anti-Tip Bracket and screws
packed with the range. Failure to install the Anti-Tip Bracket will
allow the range to tip over if excessive weight is placed on an open
door or if child climbs upon it. Serious injury might result from
spilled hot liquids or from the range itself.