Use and Care Manual

E25
DRAWER AND DOOR
IMPORTANT: Do not allow excess water or cleaner to enter
any holes or slots in the door.
TO CLEAN OVEN DOOR
1 Clean the door and drawer frequently to remove dust, spatters
and ngerprints. Wipe door surfaces with a slightly damp,
non-abrasive cloth, using mild soap and water.
2 For burned-on residue on interior door glass, use a glass
cleaning compound and/or a razor scraper.
3 Clean enameled portions of the door interior with a non-
abrasive sponge and soapy water.
4 Clean exposed metal portions with stainless-steel cleaner
to remove streaks.
The oven door can be removed for easier cleaning, servicing
or installation.
WARNING
FIRE HAZARD
• When reinstalling the oven door, conrm it operates and
seals correctly. Heat escaping from around the door could
ignite cabinetry if the door gasket does not seal completely.
• If the gasket is worn, frayed or damaged in any way, contact
a qualied service provider for repair. To maintain proper
door seal, do not rub or clean the door gasket, as it has a very
low resistance to abrasion.
TO REMOVE OVEN DOOR
1 Open the door fully.
2 On both door hinges, ip down the lock mechanism. The
lock will engage with the door when the door is moved as
if it is being closed.
3 Rotate the door toward closed position, stopping when the
door is about 2 inches from closed position.
4 Grasp the door rmly from both sides and lift the door up and
away from the oven face. Do not lift the door by the handle.
TO REPLACE OVEN DOOR
1 Holding the door rmly from both sides, align the door to
the oven so the hinges slip back into the openings.
2 Rotate the door toward closed position, stopping when the
door is about 2 inches from closed position. Allow the door
to drop into the notches on the hinges.
3 Rotate the door until fully open and ip up the locking
mechanism.
4 Ensure the door opens and closes correctly and is sealed
properly. If the door does not operate correctly, remove the
door and reattempt installation or contact a qualied service
provider.
TO REMOVE DRAWER
It is not necessary to remove the drawer for cleaning, but if
desired, it can be.
1 Fully extend the drawer.
2 Engage the release levers on each side while gently pulling
on the drawer.
TO REPLACE DRAWER
1 Align the rails on the drawer with the slides on the range.
2 Gently push the drawer into place until fully closed. Open
and close the drawer to ensure slide rails operate properly.
CLEANING AND MAINTENANCE