Use and Care Manual

E5
SAFETY PRECAUTIONS
IMPORTANT Read all instructions carefully before installa-
tion and operation. Keep this Operation Manual for future use.
Sharp Slide-in Electric Range is manufactured in compliance
with the relevant safety standard.
WARNING
Failure to follow these warnings could result in
a re or explosion causing property damage, personal injury or
death. To reduce the risk of re, electric shock or injury, use
only as intended and take the following precautions.
GROUNDING THE APPLIANCE
This unit must be supplied with the proper voltage and fre-
quency and connected to an individual, properly grounded
branch circuit, protected by a circuit breaker or fuse having
amperage as noted on the rating plate.
A 3-wire or 4-wire, split-phase AC 208Y/120 Volt or 240/120
Volt, 60 hertz electrical system must be used.
NOTE: Check local codes for required breaker size. All
electrical wiring and hookup for this unit must be done by a
qualied electrician. Make note of the location of the main
appliance disconnect.
WARNING
SHOCK HAZARD
• Improper use of the grounding plug can cause risk of electric
shock. Do not use an extension cord. If the power supply cord
is too short, have a qualied electrician or service technician
install an outlet near the appliance.
If you have any questions about the grounding or electrical
instructions, consult a qualied electrician or service technician.
ANTI-TIP BRACKET
WARNING
TIP-OVER HAZARD
• If the Anti-Tip Bracket is not installed, there is risk of the
product tipping and causing injury if someone stands, sits or
leans on the open door.
• To reduce the risk of tipping of this appliance from abnormal
usage by excessive loading of the oven, the appliance must be
secured by installing the Anti-Tip Bracket supplied. Please
refer to the Installation Manual for more information.
To check if the bracket is installed
and engaged properly, open the
oven door fully and gently apply
medium force in the center of
the handle until movement of the
appliance is detected. Continue
pressing until the Anti-Tip Bracket is engaged and movement
stops. A small amount of movement is acceptable at the back
of the appliance top, but it should be stable and not tip once
the Anti-Tip Bracket is engaged. Stop pressing on the door and
close the oven.
To check if the unit will not slide out, open the oven fully and
apply gentle outward pressure. The unit should not slide toward
you. If it does, refer to the Installation Manual.
Anti-Tip Bracket
Leveling Leg
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE