Installation Manual

4
E
E
E
E
ELECTRICAL REQUIREMENTS
If codes permit the use of a separate ground wire, it is recommended
that a qualied electrical installer evaluate the ground path to ensure
it is adequate and the wire gauge is in accordance with local codes.
Do not use an extension cord.
IN U.S.A.
Ensure the electrical connection and wire size are adequate and in
conformance with the National Electrical Code, ANSI/ NFPA No.
70-latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
IN CANADA
Ensure the electrical connection electrical connection and wire
size are adequate and in conformance with CSA standard C22.1,
Canadian Electrical Code, Part 1 - latest edition, and all local codes
and ordinances.
A copy of the above code standards can be obtained from:
Canadian Standards Association
178 Rexdale Blvd.
Toronto, ON M9W 1R3 CANADA
WARNING
ELECTRICAL SHOCK HAZARD
• The electrical power to the oven branch circuit must be shut
off while line connections are being made.
• DO NOT use an extension cord with this appliance.
• Electrical ground is required on this appliance. The free end
of the green wire (the ground wire) must be connected to a
suitable ground. This wire must remain grounded to the oven.
• If cold water pipe is interrupted by plastic, non metallic gaskets,
union connections or other insulating materials, DO NOT use
for grounding.
• DO NOT ground to a gas pipe.
• DO NOT have a fuse in the NEUTRAL or GROUNDING
circuit. A fuse in the NEUTRAL or GROUNDING circuit
could result in an electrical shock.
• Check with a qualied electrician if you are in doubt as to
whether the appliance is properly grounded.
• Failure to properly ground appliance could result in death, re
or electric shock.
ELECTRICAL CONNECTION
To properly install your oven, determine the type of electrical
connection you will be using and follow the instructions provided
for it here.
• Oven must be connected to the proper electrical voltage and
frequency as specied on the model/serial number rating plate.
All models are dual rated, and designed to be connected to either
208/240V AC, 60Hz, 3-wire or 4-wire, two phase power supply.
CIRCUIT REQUIRED
208V, 60Hz - 12AMP 240V, 60Hz - 15AMP
• The electrical supply should be a 3-wire or 4-wire, two-phase AC.
Install a suitable conduit box (not furnished). An appropriately
sized, UL conduit connector must be used to correctly attach the
conduit to the junction box.
IMPORTANT: Local Codes vary. Electrical connections and
grounding must comply with all applicable local codes.
If local codes permit grounding through the electrical supply neutral,
connect both the white neutral wire and the green ground wire from
the oven to the white neutral electrical supply wire.