Operating instructions

Extron • System 8/10 PLUS • User’s Manual
Rear Panel Connections
2-5
Video Output Connections
The System 8/10 PLUS has three sets of BNC output connectors (RGBHV,
Composite, and S-Video). Which output connectors are active depends upon
which type of input is selected. These connectors provide outputs from the
System 8/10 PLUS to the video projector or display monitor. When an input
channel is selected, the corresponding LED lights to show the format of the
selected video and which output is being used.
Only one output can be active at any given moment, unless the VLB (Video Loop
Back) feature is being used.
All output signals have the same format as the selected input. They are switched
to the output unaltered. That is: RGBHV input signals are RGBHV output signals,
composite video input signals are composite output signals, and S-Video input
signals are S-Video output signals. Thus, if multiple input signal types are used,
such as audio on the R and B inputs, the same multiple output signals will be on
the corresponding output to the projector or display monitor.
1. LED Output Indicators (See in figure above.)
An LED lights to identify which of the three outputs is currently being used.
2. RGB Output Connections ( )
Attach BNC cables to outputs labeled “R”, “G”, “B”, “H/HV”, and “V”.
3. Composite Video Output Connections ( )
Attach a single BNC cable to the output marked “Video”.
4. S-Video Output Connections ( )
Attach the Y (luminance) cable to the BNC connector marked “Y” in the S-Video
section and the C (chroma) cable to the BNC connector marked “C”.
5. If the audio for the selected channel uses the Phoenix® input connector, then the
audio output must use the Phoenix output connector ( ). See next page.
Video Output