User Manual

30
■ Errors on the communication conditions
1
Press a/b to select “DISTANCE”, and
then press ENTER.
2
Press c/d to select the desired
distance, and then press ENTER.
•“ADJUSTING DISTANCE SETTING.” is
displayed on the screen and the
communication distance is set
automatically.
3
Press MENU to return to the main
screen.
Note:
• Automatic channel selection is only made
when the TV main unit is first switched on
or when the function is selected from the
menu.
• If reception has become poor after
changing the locations of the Wireless
Center and TV receiver, the problem may
be corrected by resetting the
communication channel and
communication distance.
Transmission Setting (Continued)
[3] Setting Distance
Select the DISTANCE mode that gives the best reception and picture quality.
FAR
MID
NEAR
Setting
Picture
Quality
Data Error
Correction
NEAR
Best
Weak
Worst
Strong
MID
FAR
BATTERY CHARGE AND TRANSMISSION SETTING (Continued)
STATUS:A
DISTANCE
RETURN
[ FAR]
STATUS:NEAR
TRANSMISSION SETTING
CHANNEL
[ AUTO]
Displayed in yellow
ADJUST ING D I STANCE SETT I NG.
CHVOL
POW
ER
ENTER
DISPLAY
MUTE
SLEEP PIC. FLIP
BRIGHT TV/VIDEO MENU
FLASH-
BACK
STATUS:A
DISTANCE
RETURN
[NEAR]
TRANSMISSION SETTING
CHANNEL
[ AUTO]
ENTER/
a/b/c/d
MENU
NEAR: Enables finer picture quality.
MID: Enables normal picture
quality and middle distance
transmission.
FAR: Enables longer distance
transmission. (Picture quality
becomes relatively poor.)
Error message
SIGNAL COULD NOT
BE RECEIVED
SIGNAL COULD NOT
BE RECEIVED
WEAK SIGNAL
Color
Red
Yellow
Yellow
Description
Continues to be indicated as long as no signal is
received.
Indicates no connection can be made to the
Wireless Center due to interference of radio
waves. The indication is red initially, and
changes to yellow after approximately 10
seconds. When using a fixed channel (A, B,
or C), set to “AUTO” or try switching to another
channel to connect to the Wireless Center.
Is indicated for 10 seconds, then goes out
temporarily. This operation is repeated every 10
minutes.
* Interference of radio waves denotes radio waves in the 2.4GHz frequency wave
band complying with the IEEE802.11b specifications. Since this function cannot
detect radio waves in the 2.4GHz frequency wave band other than those that
comply with the IEEE802.11b specifications, no yellow indication will appear should
such radio waves be the cause of interference.