Operation Manual

240
16
EURO Migration Function
Basically your POS terminal can be automatically modified to correspond to the introduction of EURO by
executing the operation “EURO STATUS” in X2/Z2 mode. However, there are several options you must set
depending on your need. So, please carefuly conduct necessary settings.
For details, contact your authorized SHARP dealer.
EURO status:
You can select status from following 4 types ((A), (B), (C), or (D)). And the selectable type is decided as
follows for each status. Type (A) is the base status (initial status).
From type (A)
selectable Type (B), (C), or (D)
From type (B)
selectable Type (C), (D)
From type (C)
selectable Type (D)
The marked items “—” is remaining the current data.
Procedure
LIST
ENTER
Select X2/Z2 mode 6 EURO STATUS
Select B, C, or D
NOTE
It is executed some of following jobs which is needed for each status.
(1) Issue general Z1 report. (2) Issue general Z2 report. (3) Clear GT1/GT2/GT3. (4) Change PGM
function “Total and change amount printing — With foreign/Domestic only”. (5) Change PGM function
“Exchange1 amount printing for total validation print — YES/NO” and “Total validation print amount
printing — With foreign/Domestic only”. (6) Change PGM function “Exchange1 calculation method —
Division/Multiplication”. (7) Set “Domestic currency symbol” as EURO symbol. (8) Set “Domestic TAB”
as 2. (9) Set “Exchange1 currency descriptor” as the suitable data. (10) Set “Exchange1 TAB” as the
suitable data. (11) Convert the preset unit prices of Dept./PLU.
NOTE
This job cannot set below additional EURO function. Below items must be set by each PGM job after this
job.
(1) Exchange1 rate, (2) “Check, Credit operation for Exchange1 — YES/NO”
Items Type (B) Type (C) Type (D)
General Z1 report ISSUE ISSUE ISSUE
General Z2 report ISSUE ISSUE ISSUE
GT1/GT2/GT3 memory — CLEAR CLEAR
Exchange1 amount printing for total and change YES YES NO
Exchange1 amount printing for total validation print YES YES NO
Exchange1 calculation method DIVISION MULTI MULTI
Domestic currency symbol — [EURO] [EURO]
Domestic TAB — 2 2
The current
Exchange1 currency descriptor [EURO] domestic —
currency symbol
Exchanger1 TAB 2
The current
—
domestic TAB2
Conversion of the preset unit prices of Dept./PLU
(You can program in the PGM2 mode not to — CONVERT CONVERT
convert the preset unit prices of Dept./PLU.)