Service manual

1 – 6
UX-310DE
FO-730DE/NX-530DE
3. Assembly and connections
Plug the power lead into a 220-230 V, 50 Hz, earthed (2-prong) AC
outlet.
• Caution: The mains outlet (socket outlet) should be installed near
the equipment and be easily accessable.
• The machine does not have a power on/off switch, so the power
is turned on and off by simply plugging in or unplugging the power
lead.
Note: If your area experiences a high incidence of lightning or power
surges, we recommend that you install surge protectors for
the power and telephone lines. Surge protectors can be
purchased from your dealer or at most telephone specialty
stores.
Connect the handset as shown and place it on the handset rest.
♦ The ends of the handset cord are identical, so they will go into
either socket.
Insert one end of the line cord into the socket on the back of the
machine marked TEL.LINE. Insert the other end into a wall telephone
socket.
Attach the original document support.
Note: The original document support has a top side and a bottom
side. If you cannot insert the tabs on the support into the holes,
turn the support over.
Make sure the handset cord
goes into the socket marked
with a handset symbol on the
side of the machine!
Use the handset to make ordinary
phone calls, or to transmit and receive
documents manually.
Attach the paper tray extension.
♦ Pull the paper release plate forward. Insert the paper tray extension
horizontally into the notches in the paper tray. Rotate the paper
tray extension up until it snaps into place.
4. Loading printing paper
You can load letter or legal size paper in the paper tray. The maximum
number of sheets is:
♦ 60 for paper from 60 to 80 g/m
2
♦ 50 for paper from 75 to 90 g/m
2
Fan the paper, and then tap the edge against a flat surface to even
the stack.
TEL.
SET
TEL.
LINE
N
FN
Pull the paper release plate toward you.