Specifications
Messages and Signals
91
9. Trouble-
shooting
INCORRECT FILM/
CHECK FILM
The wrong type of imaging film is loaded in the
machine. Printing is not possible. The machine can
only print when SHARP UX-9CR imaging film is
loaded.
LINE ERROR Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see
Line Error
on page 86.
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
The memory is full. You may have too many
messages recorded in the answering machine. To
erase messages, see page 30.
This message may also occur during fax reception if
too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional
message will indicate the problem), resolve the
problem so that printing can continue (see
Substitute
Reception to Memory
on page 69). If you are
attempting to transmit from memory, see
If the
memory becomes full
on page 59. If you are copying,
see
If MEMORY IS FULL appears
on page 70.
MEMORY PRINTING The fax is preparing to or printing out a document
from memory.
NEAR END OF FILM/
USE SHARP SUPPLY
This message appears approximately 3 m from the
end of the imaging film (approximately 10 pages can
still be printed), and alerts you that you will soon need
to replace the film.
NO DATA This appears if you attempt to search for an auto-dial
number when none have been stored.
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
ON HOOK DIAL
The key has been pressed and the fax machine
is waiting for you to dial.
OVER HEAT The print head has overheated. Operation can be
continued after it cools. If overheating frequently
occurs, try changing the print contrast setting to
LIGHT (see page 16).
all.bookPage91Tuesday,July15,20039:53AM