User`s manual

Chapter 2 Chapter 2
40
2.1.2.2 Protection against Electrostatic Discharge (ESD)
An electrostatic discharge occurs between two objects when an object carrying
static electrical charges touches, or is brought near enough, the other object.
Static electrical charges appear as a result of friction between surfaces of
insulating materials, separation of two such surfaces and may also be induced by
electrical fields.
Routine activities such as walking across an insulating floor, friction between
garment parts, friction between objects, etc. can easily build charges up to levels
that cause damage, especially when humidity is low.
Whenever feasible, during installation works use standard ESD protection wrist
straps to discharge electrostatic charges. It is also recommended to use garments
Warning:
To reduce the risk of exposure to hazardous radiation:
Do not try to open the enclosure. There are no user-serviceable
components inside.
Do not operate controls, make adjustments, or perform
procedures to the laser device other than those specified herein.
Allow only authorized Tainet service technicians to repair the unit
herein.
Allow only authorized Tainet service technicians to repair the unit.
Caution:
MUXpro internal boards contain components sensitive to ESD. To
prevent ESD damage, do not touch internal components or
connectors.
If you are not using a wrist strap, before touching a MUXpro unit
or performing any internal settings on the MUXpro, it is
recommended to discharge the electrostatic charge of your body
by touching the frame of a grounded equipment unit.