User`s manual

Chapter 2 Installation
47
LED Indicator /
Buttons
Status Description
RST Press Reset the hardware by pressing this button
ACO Press Alarm Cut Off button, press to clear the alarm
The components located on the rear panel are arranged in several functional
groups:
 Power supply: The rear panel includes only the AC or the DC power
connector (in accordance with order), for connection of the MUXpro 820
supply voltage and protective ground. The AC connector has a built-in fuse.
 LAN port: There are six Ethernet interfaces (4 VLAN ports, 2 transparent ports)
terminated in LAN 1, LAN 2, LAN 3, LAN 4, LAN 5 and LAN 6. Each
connector has a pair of built-in indicators.
 E1 interface: 16 E1 ports for SCSI II female connector, 8 for built-in E1 and
the other 8 E1 ports are tributary. Tributary E1 card is hot swappable.
2.1.6 Connections
2.1.6.1 Installing a MUXpro Unit
MUXpro units are intended for installation on desktops, shelves or in 19” racks.
For rack installation, a rack mount kit is available from Tainet. Refer to the
installation leaflet of the rack mount kit for detailed instructions.
Do not connect power to the enclosure before it is installed in the designated
position.
2.1.6.2 Cable Connection, General
Before starting, refer to the site installation plan and identify the cables intended
for connection to the MUXpro unit.
Caution:
Before installing a MUXpro unit, review the safety
precautions given in Section 2.1.2