User`s manual
Chapter 2 Chapter 2
50
2.1.6.4 Connecting MUXpro Links to Network Ports
The network connections are made in accordance with the interface type ordered
for your MUXpro:
Optical Cable Connection Instructions
Optical interfaces: connect to the optical connectors in the Optical 1 and Optical 2
areas.
To connect optical cables to the MUXpro network interface:
For each optical interface (Optical 1 or Optical 2), refer to the site
installation plan and identify the corresponding pair of cables intended for
connection to the corresponding TX and RX connectors.
Connect the prescribed transmit fiber (connected to the receive input of
the remote equipment) to the TX connector. Leave enough slack to
prevent strain.
Connect the prescribed receive fiber (connected to the transmit output of
the remote equipment) to the RX connector of the same interface. Leave
enough slack to prevent strain.
2.1.6.5 Connecting MUXpro to E1 Ports
To connect cables to the MUXpro E1 ports
The connection to the MUXpro E1 ports is made to be suitable for the SCSI II;
female connectors designated E1. Different model of MUXpro Series has different
amount of E1 ports. For MUXpro 820, there are 8 built-in E1 ports. For MUXpro
8216, there are 16 E1 ports, 8 for built-in and others are tributary.
Figure 2-6 BNC connectors for 16 ports unbalanced E1 panel
Figure 2-7 Wire-wrap connectors for 16 ports balanced E1 panel