User`s manual
Chapter 2 Installation
51
Figure 2-8 Converter cable
Figure 2-9 On the back of the unbalanced E1 panel
2.1.6.6 Connecting MUXpro to LAN Ports
To connect cables to the MUXpro LAN ports
The connection to the MUXpro LAN ports is made to the RJ-45 connectors
designated LAN. Use a standard (station) cable wired point-to-point for connection
to any type of Ethernet port (hub or station).
2.1.6.7 Management Connections
To connect cables to the MUXpro supervisory ports
The connections to the CRAFT connector are made as follows:
Connection to a supervision terminal with 9-pin connector: by means of a
straight cable (a cable wired point-to-point).
Connection to modem with 9-pin connector (for communication with
remote supervision terminal): by means of a crossed cable.
Additional connection options are presented in Appendix A .
To connect to a management station, Telnet host or Web browser
The link to network management stations using SNMP, to Telnet hosts and/or Web
browsers can be provided in two ways:
In-band, it can be linked through the network. This connection is
automatically available when the network cables are connected, provided