Specifications

l§ii
Connections
0
Q
0
Disconnecting TV Cable
Disconnect the aerial cable from the back of
your TV set.
Connecting Aerial Cable to VCR
Connect the aerial cable to the ANTENNA IN
terminal of your VCR.
b
ANTENNA IN
Connecting VCR to TV
Connect the supplied coaxial cable to the RF OUT terminal of the VCR. Plug the other end into your
TV’s ANTENNA IN terminal.
RF OUT
TV back panel
ANTENNA IN
ANTENNA IN
!!§I
Adjusting the Video Channel
To view the output of your VCR on the television screen, you must select an unused channel on your TV
and tune it to the output of your VCR (factory preset to UHF channel 37).
0
0
0
0
A
0
0
l
Make sure both units (TV and VCR) are connected (Power cord) to the power point.
Turn on your TV.
Select an unused channel on your TV.
Set the power on the VCR to off. (If the VCR is ON, press the OPERATE button to turn off the
power.)
Keep pressing the MENU button for more than two seconds to light up the “VCR” on the VCR
display.
Adjust the tuning of the selected TV channel until the MENU pattern appears on your TV screen.
(Refer to your TV operation Manual for Tuning procedures)
l If interference or a beat pattern is received when the test pattern is tuned in, use a small screwdriver to turn the RF
converter output channel adjuster to change the VCR output channel, and then retune your TV as above.
0
l
a
RF converter output channel
adjuster (CHANNEL) (UHF
OPERATE
b OFF
-