Service manual

VC-A410U

VC-H810U

4-24 INSTALLING THE MASTER CAM (AT

REAR SIDE OF MECHANISM CHASSIS)

1. Make sure beforehand that the shifter is at the point as

shown below.

2. Place the master cam in the position as shown below.

Note:

See the figure below for the phase matching between the

master cam and the casecon drive gear.

3. Finally fix with the E ring.

4-25 REPLACEMENT OF LOADING MOTOR

• Removal

• Replacement

Remove the loading motor, and install the replacement

loading motor as shown below.

Figure 4-46.

Figure 4-44-2.

When installing the master cam,

align the casecon drive gear

round mark with the half-round

notch of master cam.

The loading motor pressing-in must be less than 14.7 N

(1,500 gf).

Adjust the distance between motor and pulley to 10.2

mm).

E ring

(XRESJ30-06000)

Master cam

Fully turn

clockwise

Fully turn counterclockwise

Figure 4-44-1.

Face the wide tooth side ward

Master cam

Casecon drive gear

10.2 mm

Round mark

Half-round notch

+0.2

–0.2

Apply grease

No grease

Figure 4-45.

+0.2

–0.2