Specifications

7. Remove the exposure lamp [A] from the rear spring plate by moving the
lamp toward the front.
8. Install a new lamp. Use a strip of paper as shown to hold the lamp. Set
the rear terminal first.
NOTE: a) Make sure that the lamp is set so that the terminal side of the
exposure lamp routes through the rear side of the copier.
b) Make sure that the insulators [B] are properly supported with the
terminals [C].
c) Make sure that the blister [D] on the lamp points towards the
reflector opening (left side of the copier) as shown.
d) Check the exposure lamp position, light intensity and ADS sensor
adjustment. (See Exposure Lamp Position Adjustment, Light
Intensity Adjustment and ADS sensor Adjustment.)
[A]
[B]
[C]
[D]
1 December 1990
5-12