Specifications

12.8 FRICTION ROLLER REPLACEMENT
1. Remove the duplex unit from the tray. (See Duplex Unit Removal.)
2. Turn over the duplex unit as shown.
3. Unhook the springs [A] from the roller bracket [B].
4. Remove the lock pin [C] and the roller assembly.
5. Remove the roller [D] (1 snap-ring and shaft) from the bracket and replace
it.
NOTE: This friction roller has a one-way clutch. Be sure to install the roller
so that it rotates in the direction of the arrow. (See illustration.)
[C]
[A]
[D]
[B]
1 December 1990
10-27