Service manual

VE-CG30U
VE-CG40U
9
5.TEST MODE FUNCTION
[Note]: The meaning of TEST MODE FUNCTION Under this test mode, following things can be done.
1; Check and change EEPROM values, if required. 2; Apply several tests and adjustments.
3; Check the version # of firmware.
MENU Key
How to enter each test mode
1) Press the or key to select the desired test mode.
Each time you press the or key, each test item is displayed.
Test Nos. and the corresponding test items are as follows.
TEST NOS. Test item Display
TEST 0 EEPROM address change 0 CANGE E2PROM
TEST 1 LCD test pattern display 1 TEST PATERN
TEST 2 Default settings 2 SET SHIPPING
TEST 3 White balance low color temp. adjustment 3 WB LOW TEMP
TEST 4 White balance high color temp. adjustment 4 WB HIGH TEMP
TEST 5 CCD pixel defect correction 5 DEFECT WHT BLK
TEST 6 Not use in service 6 DEFECT WHT BLK
TEST 7 AF adjustment 7 FOCUS
TEST 8 Not use in service 8 CCD SENSITIVITY
TEST 9 Shutter timing adjustment (open side) 9 SHUTTER OPEN
TEST A Shutter timing adjustment (close side) A SHUTTER CLOSE
TEST B Not use in service B WB HIGH CALIB
TEST C Not use in service C LCD POSITION
TEST D Battery adjustment D BATTERY VOLTAGE
TEST E Not use in service E WB LOW CALIB
TEST F Not use in service F TEST F
3X OPTICAL ZOOM
DIGITAL STILL
Shutter
Power Key
How to enter the test mode (TEST MODE initial screen)
Reset the user mode settings first. Download the user mode settings reset program to the SD card to create a test mode
setting card. Regarding Test Mode Setting Program("Shce0009.dat" & "Shcu0009.dat"), please refer to Service
Information. Insert this SD card for resetting the user mode settings in the camera and turn on the power while pressing
shutter. Then, "do you vertion up?; Do: Push Shutter, No: Do Not" appears on the CGS display. Next press shutter to
set the factory mode setting. (If it is not mecessary to reset the user mode setting, turn off the power and remove the
SD card.) The message changes to "vertion up start", and "version up complete" appears soon. After checking that
the power has turned on, turn it off and remove the SD card. Now restting the default settings is finished.
Version Up Complete
Do You VersionUp?
Do : Push Shutter
No : Do Not
Set the camera to the factory mode in the following procedure.
1) Turn on the power by pressing the power key with the MENU key pressed down.
2) When entering the test mode, the screen on the right(TEST MODE initial screen)
MENU Key
or key
SET key
TEST MODE
BOOT VER xxxxx
IPL VER xxxxx
MAIN VER xxxxx
SUB VER xxxxx
USB SNUM xxxxxxxx
0 CHANGE E2PROM
2) If the desired test item is found, press the SET key to select it.
TEST MODE initial screen
[Note]: When finishing the service works, the camera must be set USER MODE again. In order to set the camera back
to USER MODE, execute TEST 2 written as "User mode settings" on page 11.