Manual

Charging the Battery Pack
Power switch
CHARGE indicator
2
3
Insert the battery pack into the VIEWCAM
(see page 7). Make sure that the Power
switch is set to OFR
• The battery pack will not charge when the
Power switch is set to CAMERA or VCR.
Insert the AC plug of the AC adapter into a
power outlet.
Open the terminal cover on the VlEWCAM
and insert the DC plug of the AC adapter
into the DC IN jack on the VIEWCAM.
• The CHARGE indicator will light up in red.
,__ Terminal cover
OC,Hjac
TOtPe_W_ _'_
4
When the battery is fully charged, the
CHARGE indicator will light up in green.
Remove the DC plug from the VlEWCAM,
and close the terminal cover.
Caution:
• When removk_g the plugs, grasp the plug, not the
cable.
Charging time and maximum continuous
recording and playback times
BT-H22 approx, approx, approx.
3 hr. 1 hr. 35 min. 1 hr. 35 min.
BT-H32 approx, approx, approx.
6hr. 3 hr. 10 min. 3 hr. 10 min.
Notes:
• Using the zoom (see page 19) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than 50%
in the actual recording time compared to the
maximum continuous recording time listed
above,
• The charging time and recording time may vary
depending on the ambient temperature and the
condition of the battery pack,
• It is recommended that you have enough battery
packs on hand to provide two to three times your
estimated recording time.
• See page 52 for more information on using the
battery pack.
Caution:
• Charge only SHARP model BT-H22 or B%H32
battery packs. Other types of battery packs may
burst, causing personal injury and damage.
::i'ii_iiii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!i!i!iil
iiiiiiii!ii!ii_!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i