Manual

Remaining Recording Time
Display
When the VIEWCAM is recording in Camera
mode, about 10 minutes before the tape
reaches the end, an on screen indicator
displays the approximate remaining recording
time,
DISPLAY button
10 rain,-8 rain, TAP E
8 rain, 6 rain, TAPE
6 rnin. 4 min, TAP E
4 rain. 2 min, TAPE [_[_[_
2 rain. 1 min, TAPE FIDDD
THE TAPE
ENDS SOON.
1 min,-O rain, , j _
TAPE END
/ J \
0 rain, CHANGETHE
(The tape has CASSETTE,
,!
reached the end,) TAPE END
To turn off the remaining recording time display,
press the DISPLAY button,
Notes:
• The remaining recording time displays only show
the approximate time left. Also, they vary slightly
depending on the length of tape used, (This
function's design is based on the PG120 tape
standard.)
• If you turn off the remaining recording time
display, it will reappear aRer a short interval to
indicate the new time remaining.
• The remaining recording time display appears
5 seconds after pressing the REC START/
STOP button to begin recording.
Remaining Battery Power
Display
When using the VIEWCAM with the battery
pack as the power source, you can turn on and
off the remaining battery power display by
pressing the DISPLAY button,
I[ the battery power becomes very low, a
warning indicator will appeai, Replace the
battery pack,
_1 (Green)
i--1 (Green) Remaining battery
power display
D (Red)
BATTERY IS
TOO LOW,
41" Warning indicator
\ / /
....BATTERY,
Notes:
• Use the remaining battery power display only as
an approximate indication.
• The battery power display may change to either
a higher or lower level if you set the Power
switch to OFF and then back to CAMERA or
VCR,
• In cold environments, the red remaining battery
power display may appear sooner. The battery
pack, however, can be used until the warning
indicator appears Replace the battery pack at
this time,
• Battery consumption may vary depending on the
condition of use.
• Use of the zoom function when the warning
indicator is displayed may cause the VlEWCAM
to suddenly lose power,
HHHHHHHHHHHHHHH
20