Manual

Watching the Playback on a
TV
You can also connect the VIEWCAM to a TV to
allow a larger audience to enjoy video
playback.
1 Lift up the terminal cover on the
VIEWCAM (i) and rotate it to the right
(2).
2 Connect the VIEWCAM to your TV (or
VCR) with the supplied audio/video
cable, as shown.
._ .P.Yellow: ToVIDEO IN jack
_ White: To AUDIO IN (L) jack
3
4
Turn on the TV and set it to the "AV" or
"VIDEO" channel. (See the operation
manual of your TV.)
,, When connecting to a TV via a VCR, turn on
the VCR and set it to the "AV" or "LINE"
input channel. Operate the TV as you
normally do to see the signal from the VCR.
(See the operation manuals of your TV and
VCR.)
Turn on the VlEWCAM in VCR mode,
and begin tape playback (see page 21 ).
Caution:
,, Make sure that the VlEWCAM, TV, VCR and other
equipment to be connected have been turned
off before you make connections. Making con-
nections with any of the components left turned
on may cause picture noise or a malfunction.
Notes:
• This VIEWCAM does not have an S-video
sooket.
• When the VIEWCAM is connected to a TV for
playback, the picture on the TV screen may
flicker if the volume on the VlEWCAM is set to
downmaXimurnShould this occur, turn thevolume(seepage 21).
• Close the terminal cover after use.
Audio/video carte
(supplied)
--To AUDIO/VIDEO jack
22