Manual
Advanced Features
iiiiii!ii!_iil;_!!!!!!!!!!il
iiiiiiiiiiiiiiii_ii!!!i!i_il;_ii!:iiiiiiiiiiiiiiiil;i
49
Editing
Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This VIEWCAM lets you monitor tile source pro
gram on tile built in LCD monitor without
having to connect it to an external TV or video
monitor.
Connect the VIEWCAM to a VCR with tile sup
plied audio/video cable, as shown,
Yellow: ToVIDEO INjack
Recording White:ToAUDIO IN (L)jack
Audio/video cabIe -.................--_
(supplied)
Playback
_jack
Cutting Unwanted Sequences
Play back the tape to be edited, and locate
the beginning and end of the sequence
you wish to cut. Write down the tape
counter readings at the beginning and end
of that sequence (see page 37). Then
rewind the tape to the beginning of the
portion that you wish to keep.
2 Load a video cassette into the recording
VCR.
Set the Power switch on the VIEWCAM to
VCR. Press the PLAY button ( _.-) on the
VIEWCAM and the Record button on the
VCR at the same time.
4 Press the Pause/Still button on the VCR to
pause recording when the source tape
reaches the beginning of the sequence to
be cut.
5 Press the Pause/Still or Record button on
the VCR to resume recording when the
source tape reaches the end of the
sequence to be cut.
To stop editing
Press the Stop buttons on the VIEWCAM and
the VCR,
Notes:
• Some of the transitions between edited sequences
may be slightly off
• There may be picture noise during video search or
still picture playback This does not imply a defect in
the VIEWCAM
Setting Edit Mode
Picture quality inevitably decreases when
dubbing from tile VIEWCAM to a VCR, To
minimize tile quality reduction, set tile
VIEWCAM to Edit mode,
1 Set the Power switch to VCR, then press
the MENU button until _ appears.
2
MENU
"EDIT OFF
MENU _REMOTE ON
_[IIl PIC-
",-I ISEThUREI
@®@®®
Press the v or _ button (1_) to select
"EDIT", then press the SET bu_on (_)
(2) to select "ON".
MENU
i) _EDIT ONISETI .REMOTE ON
ITU_EI
Notes:
• The EDIT mode does not function when the
VIEWCAM is recording
• After you finish editing, set the EDIT menu item back
to "OFF"