Technical information

Installing the Mwave Support Software
DOS
Installing for DOS
To install the Mwave support software for DOS, do the following:
1 Turn on the computer.
2 Insert the Mwave DSP Features Diskette 1 for DOS into
the diskette drive.
3 At the command prompt, type A:INSTALL; then press
Enter.
The following screen, which enables you to specify the
directory location of Mwave support software, appears:
Please specify the directory for the
installation of Mwave products.
Destination Path
OK
Cancel
c:\MWD
4 If this directory is acceptable, press Enter. Otherwise,
type the directory name; then press Enter.
5 Follow the instructions on the screen.
6 After the installation is complete, remove any diskette
from the diskette drive; then restart DOS to activate the
Mwave support software.
You have completed the installation of the Mwave support software
for DOS.
194 IBM ThinkPad 755CX User's Guide