Specifications

Preparation
Use the optional VR33CH car battery adaptor/battery
charger (or the VR-41 OCA car battery adaptor) when
you want to power the VIEWCAM from the cigarette
lighter socket of your car.
Perform steps 1 through 3 under “Powering the
VIEWCAM from an AC Outlet” (page 10).
Plug the DC cable into the DC OUT jack on the
VR-33CH (or VR-41 OCA).
Next, start the car engine and leave it idling. Then
inset-t the plug into the cigarette lighter socket. (The
POWER indicator on the VR-33CH will light up.)
i When powering from
1 your car’s cigarette lighter
battery charger
I
VR-33CH (optional
I
DC OUT jack I
I
i
I
or
;
I_
I
I
I
I
I
I
I
I
I
I
I
I
I
I
Car battery adaptor i
I
I
I
I
I
I
I
--__----_---__--__-_-_-------
J
l See the VR-33CH (or VR-410CA) operation
manual for details.
l The battery pack can be recharged by using the
VR-33CH in basically the same manner as the
supplied AC adaptor/battery charger (see page 9).
l The VR-41OCA cannot be used to recharge battery
packs.
Use in only DC 12 V or 24 V negative ground
system cars. Positive-ground car batteries
CANNOT BE USED. Check your car-operation
manual or consult a local car dealer.
Use the VR-33CH (or VR-410CA) only when the
car is idling or being driven. Otherwise, the car’s
battery will be drained.
Charge only SHARP model BT-N1 or BT-Nil,
BT-H11 battery packs. Other types of batteries may
burst, causing personal injury and damage.
Before starting the car engine, the VR-33CH (or
VR-41 OCA) must be unplugged from the cigarette
lighter socket.
Before removing either the DC plug or the cigarette
lighter plug, the VIEWCAM’s Power switch should
be set to OFF.