Specifications

Preparation
Inserting the Battery Pack
1 Slide the battery compartment door release
on the bottom of the VIEWCAM in the
direction of arrow (@I), to open the battery
compartment door (0).
Battery
compartment
2 Inset-t the battery pack into
ment and push it in completely.
the compart-
door release
3 Close the door pressing it firmly in the
centre until it clicks.
Removing the Battery Pack
1
2
Perform step 1 in the above procedure.
With the VIEWCAM facing down, press the
lock as shown, and remove the battery
pack.
Battery Pack Handling
l Make sure that you take enough battery packs with
you to provide two to three times your estimated
recording time.
l Recording time will be reduced in cold weather.
l The battery will drain in Recording Standby mode.
Turn off the power if you will not be recording again
soon.
m
3
x
z
. ALWAYS STOP THE TAPE AND TURN THE
POWER OFF, BEFORE REMOVING THE
BATTERY PACK. If you remove the battery pack
during recording or playback, the tape will remain
wound around the video head drum and may be
damaged. Should the power source (battery or
adaptor) become disconnected during operation,
reconnect it again immediately.
l Do not expose the battery compartment door to
strong force, as it may come off.
l Be sure to close the battery compartment door firmly.
especially before using the VIEWCAM. If you do
not, the battery pack may come off or VIEWCAM
operation may fail because of the poor contact
pressure.
l Remove the battery pack from the VIEWCAM or
disconnect the VIEWCAM from the AC adaptor if
the VIEWCAM will not be used for a long time.
l When removing the battery pack, do not tilt the
VIEWCAM so that the battery compartment faces
down. The battery pack may fall out.
Lock