Specifications

Before Requesting Service
Symptom
Possible cause Suggested solution
Infrared remote control does
not function.
“REMOTE” menu item is set to
Set “REMOTE” menu item to “ON”
“OFF”.
(P. 29).
Remote control’s lithium battery has Replace remote control’s lithium
run down.
battery with a new one (p. 16).
Remote control being used beyond
Use remote control within its
its operating range. operating range (p. 29).
Intense daylight falling on VIEW-
CAM’s photoreceptor.
Avoid lettrng intense daylight fall on
VIEWCAM’s photoreceptor (p. 29).
Obstacle between remote control
and VIEWCAM’s photoreceptor.
Remove obstacle or use remote
control from different angle (p. 29)
Cassette cannot be inserted.
Cassette is not right side up, or is Check cassette positionrng and
backwards. reinsert (p. 15).
Cassette won’t eject.
VIEWCAM is in Recording mode. Press REC START/STOP (or STOP)
button to stop tape, and try again
(P. 20).
Battery pack cannot be
ejected.
Battery pack inserted in an incorrect Call for service.
manner.
No tape movement in Fast
Forward mode.
Tape already completely wound. Rewind tape to desrred point (p. 27).
No tape movement in Rewind Tape already completely rewound.
Fast forward tape to desired point
mode.
(P. 27).
Notes:
l This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, turn off the power and disconnect the unit from
any power sources, including lithium batteries, etc. Then reconnect the power sources (to resume
operation).
l If the characters displayed on the monitor screen appear to malfunction, disconnect the power source
and remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the
power on again. The characters on the monitor should be normal. Set the date and time, then resume
operation.
-