Manual

Available mode:
TAPE-VCR
You can use this camcorder to convert from
analog signal (e.g. video recorded on 8 mm or
Hi8 tapes) to digital signal.
Connect the audio/video cable and DV cable
as shown below.
I Recording
To DV terminal (digital equipment)
_::_ I e.g. computer
DV cable (commercially available)
Digital signal ...
Toov
'u _ @
ToAVjack
Analog signal
Audio/video cable (supplied)
Yellow: To video output jack
White: To audio output (L) jack
Red: To audio output (R) jack
Playback
(analog equipment)
e.g. 8 mm or Hi8
camcorder
.,_,.: The arrow shows the signal flow.
Note:
o See page 2 for how to open the jack cover.
1
2
3
4
Set the camcorder to TAPE-VCR mode,
and make sure that playback stops.
Press the MENU button to display the
menu screen.
Press V or A on the operation button
to select _, then press the SET button.
Press V or A to select"ANLG-cDGTI",
then press the SET button.
5 Press V or _, to select"ON", then press
the SET button.
6 Press the MENU button to turn off the
menu screen.
7
Press the Play button on the analog
equipment
- Check the monitor on the digital
equipment to see if the picture is being
properly received.
8 Press the Record button on the digital
equipment.
Notes:
o The camcorder is not guaranteed to work with all
digital/analog equipment. Contact the manufac-
turer of your equipment for advice.
e If the camcorder outputs a video recording with
a copyright signal, the digital equipment cannot
record or save it.
,, The camcorder may not convert some input
video recordings properly (e.g. discoloration,
picture noise, muted sound), depending on the
input condition.
iiiiiiiiiii!_iiiiiiiiii_!
iii!iiiiiiii_!i_!i!!!!
iiiiii!ii!iii_iiiiiiiil
5O