Service manual

VL-Z1U

(5) PB (Record, Fast forward, Fast rewind, VSF and VSR)

mode

This mode is used for playback, recording, fast-forwarding,

fast -rewinding, VSF and VSR. In this mode, the pinch roller

is pressed against the capstan shaft and the S main brake

is located away from the S reel table.

PB (RECORD, FAST FORWARD,

FAST REWIND, VSF AND VSR) MODE

9-2. Cassette controller assembly

<Procedure for removing the cassette controller> (The cassette controller can be installed and removed without removing the cover.)

(1) Apply 3 to 4V DC to the loading motor to establish the standby mode. When removing the cover from the cassette controller, remove

the tow screws (A). (See Fig.1.)

(2) Push the lock lever in the direction shown by the arrow and move up the cassette controller. (See Fig.2.)

(3) Remove the two screws (C) and remove the down guide (D) in the direction shown by the arrow (E). (See Fig.3 and Fig.4.)

(4) Shift the cassette controller in the direction shown by the arrow (F), remove the inner arm guide shaft L and the groove of the inner

arm R toward the inside of the mechanism, and turn the cassette controller. (See Fig.5 and Fig.6.)

(5) Turn the cassette controller in the direction shown by the arrow (H) and shift it in the direction shown by the arrow (I) to remove it

from the slide chassis. (See Fig.7.)

Fig.3

Fig.5 Fig.6

Fig.1 Fig.2

Fig.4

(C)

(D)Down guide

(E)

At this position, remove the inner arm guide

shaft L toward the inside of the mechanism.

(F) (F)

At this position, remove the groove of the inner arm

R toward the inside of the mechanism.

(B)

(A)

Pinch roller

Capstan shaft

S reel table

S main brake