User manual

General Operation
5-6 BioRobot EZ1 DSP Workstation User Manual 02/2007
5.4.1 Opening the workstation door
1. Slide your fingers under the door and push it upward.
2. Rest the door on the door lock that is located near the
top of the BioRobot EZ1 DSP.
5.4.2 Closing the workstation door
1. Press the door down to disengage the door lock.
2. Gradually lower the door until it rests on the worktable.
Take care that your fingers do not get caught between
the door and worktable.
5.5 Starting and stopping a protocol run
WARNING
Moving parts [W7]
Never open the workstation door while the BioRobot EZ1
DSP is operating.
5.5.1 Starting a protocol run
After you have inserted the EZ1 Card and switched on the
BioRobot EZ1 DSP, start a protocol as follows:
1. Press “START” on the control panel.