User manual

Troubleshooting
7-2 BioRobot EZ1 DSP Workstation User Manual 02/2007
7.2 Error codes
Error code Description
10 Failed to return to origins, protocol cannot run
11 Limit error, protocol cannot run
12 Failed to return to Z axis, protocol in run
13 Failed to return to P axis, protocol in run
14 Failed to return to M axis, protocol in run
15 Failed to return to Y axis, protocol in run
16 Z axis limit error, protocol in run
19 Y axis end limit, protocol in run
20 Z axis time-out, protocol in run
21 P axis time-out, protocol in run
22 M axis time-out, protocol in run
23 Y axis time-out, protocol in run
24 Open door in motion
25 Abnormal input from bottom sensor in motion
26 Failed to initialize heating block
27 Failed to initialize motion control board
29 Memory error