User manual

11
Setup Your VorTech Pump
Aligning VorTech Pump
• Turn the speed up to the maximum speed by using the
speed control knob on the driver.
• Plug the power supply into the driver. If vibration or noise is
detected, carefully adjust the propeller housing by moving it
VERY slightly left, right, up or down, until the noise/vibration
is eliminated or minimized as much as possible.
• After alignment has been ensured, turn the speed control
knob to achieve the desired flow rate within your aquarium.
• Important: If the VorTech is not properly aligned, a strong
vibration will be heard. If the alignment is not corrected,
this can cause increased electrical consumption, excessive
wear on the components, excessive heat and excessive
noise.
Section 3.3