User manual

Wireless Driver Firmware Upgrade
Note: EcoSmart Drivers only upgrade other EcoSmart Drivers. Any EcoSmart driver with newer
firmware can upgrade another EcoSmart Driver regardless of the model number (i.e. MP10w ES
can upgrade a MP40w ES).
EcoTech Marine is continually upgrading and making your EcoSmart Pump better. Because of this,
your driver may not have the latest firmware. Fortunately, EcoTech makes it easy to upgrade your
Drivers firmware. All you need to do this process is have a driver with the latest firmware along with
the driver that you want to upgrade. Follow the instructions and diagram below to upgrade your
drivers firmware.
Note: During the firmware upgrade process, turn off all Wireless Wave Drivers and EcoSmart Driv-
ers within 100 feet of the two that you will be doing the upgrade process with. Also, move the two
drivers that you will be working with to within 3 feet of each other.
Unplug your driver then hold Mode and Set simultaneously while plugging your driver in and contin-
ue holding until the control dial has been red for approximately ten seconds. When the LED toggles
between blinks red/white, the driver is in Upgrade Mode. Release both the Mode and Set buttons.
Repeat this step for second driver.
Maintenance
36
Section 6.2
Now that both drivers control
dials are blinking red/white,
indicating they are in Upgrade
Mode, press and hold Set button
on either driver until the control
dials blink green/blue for driver
recieving new firmware and red/
green/red/blue for the driver
sending firmware. The pumps
will automatically detect which is
the latest firmware and act ac-
cordingly.
Powered Off HOLD Mode +Set
Press Set on either driver
Receiving New Firmware
Blinking Red/White
Sending New Firmware