Owner`s manual

7
2.2.4.1.Push to talk function(similar to walky-talky)
A. Communication LED on means voice is free to go out from monitor to
door camera.
B. During the conversation, press the Monitor Button for 2 seconds to
switch to push-to-talk mode. In this mode, pressing the Monitor Button
(Communication LED will turn on) will activate the one-way voice
communication to the door camera; releasing the Monitor Button
and (Communication LED turns off )allows for one-way voice
communication to come in from the door camera to the monitor.
C. This function can be useful when the environment at door camera side
becomes too noisy.
2.2.4.2. Visitor calls from door camera
A. Typical video intercom function, when call button is triggered, all
monitors will
B. In 3 seconds time, the main monitor begins to record video of the door
camera. In 20 seconds time i answer from monitor, the
system will time out. Visitor's video is recorded (figure 1).
C. If tenant answers from main monitor (pressing the monitor button ),
video recording 20 seconds, conversation time is limited
to 90 seconds.
D. If tenant answers visitor call from expansion monitor, main monitor will
cutoff, video recording will stop pre maturely.
E. Pressing the door release button to control door strike;
cutoff button can end the intercom operation.
chime and monitors will turn on.
f there is no
continues for
pressing the
2.2.4. Intercom function operations