User`s manual

3 - 4

[2] Switches (MODE, INITIAL)

MODE

Rotary

switch

0 to 9

(4 bits)

INITIAL

Push

switch

Name Type Description of functions

Sets the operation mode:

0: Regular operation mode (startup axis enable display mode) *1

1: Regular operation mode (X-axis enable display mode)

2: Regular operation mode (Y-axis enable display mode)

3: Regular operation mode (Z-axis enable display mode)

4: Regular operation mode (A-axis enable display mode)

5: - (unused)

6: - (unused)

7: - (unused)

8: System maintenance mode (system version upgrade, etc.)

9: Setting prohibited

The INITIAL switch has the following two functions:

For initial start (same as restart by power ON

When the MODE switch is set to 0 to 4, and the INITIAL switch is

held down for at least 5 seconds, the data recorded to flash ROM

is read to RAM area (*2).

For initialization

When the MODE switch is set to 8, and the INITIAL switch is held

down for at least 5 seconds, RAM area is initialized (set to the

default or factory setting state).

*1 The latest startup data is indicated for the display when "10" is set.

[Example] When direct operation is applied on the Y-axis during program

operation on the X-axis, the information of the Y-axis is displayed.

Note, however, that the information of the first axis to be started up is not

indicated even during operation if the axis that started up later has stopped.

*2 Memory that is used during actual operation