User`s manual

4 - 1

Chapter 4 Installation and Connection

4-1 Installing this module

Insert the connector for this module into the module connector on the rack panel, and tighten

the module fixing screws at the top and the bottom with the Phillips screwdriver.

• Two or more of these modules can be mounted in any of the I/O slots.

Cautions

• Firmly tighten the module retention screws. Loose screws may result in malfunction.

• Do not block the ventilation holes on this module or block the flow of air into and out from these

holes. Doing so might cause the temperature inside the module to heat up and cause

malfunction.

Turn the JW50H/70H/100H OFF.

This module is installed on the I/O slots of the rack panel (JW-6BU/13BU, etc.) for the JW50H/70H/

100H. It is not installed on the option slots.

Module connector

Rack panel

This module (JW-12PS/14PS)

Module retention screw

Phillips screwdriver

Rack panel

This module (JW-12PS/14PS)