Operation Manual

26
Maintenance
• The display shows symbols that do not
make sense.
• The display will not illuminate even
when the mode switch is not set to “”.
The machine fails to operate when any
key is pressed.
• The display is illuminated, but the
machine does not accept key entries.
• Journal paper does not feed properly in
the printer.
• Printing is faded or illegible.
• Was the machine reset in the proper way shown on
page 5?
• Is the power supplied to the electrical outlet? (Plug
in another electrical device.)
• Is the power cord firmly connected to the electrical
outlet?
• Is the mode switch properly set to the REG
position?
• Was the machine reset in the proper way shown on
page 5?
• Is the take-up spool installed properly?
• Is there a paper jam?
• Isn’t the ink roller used up?
• Is the ink roller installed properly?
Specifications
Problem Item to check
Model: XE-A102
Size: 330(W) x 363(D) x 234(H) millimeters
Weight: 5 kg
Power Source: Official (nominal) voltage and frequency
Power Consumption: Stand-by: 6.4 W Operating: 13 W
Work Temperature: 0 to 40 °C
Display: LED (Light-Emitting Diode) numeric display
Printer: 1 station print wheel selective type
Printing Capacity: Max. 13 digits
Paper Roll: Width: 57.5 mm ± 0.5 mm
Max. diameter: 80 mm
Paper quality: Bond paper
(thickness: 0.06 to 0.085 mm, weight: 47 to 64 g/m
2
)
Cash Drawer: 3 slots for bills, 6 for coins
Accessories (supplied):Paper roll 1 roll
Mode key 2
Drawer lock key 2
Instruction manual 1 copy (this manual)
Quick start guide 1 copy
Ink roller 1 (already installed)
Take-up spool 1
Fixing angle blacket 1
* Specifications and appearance are subject to change without notice.
If you encounter a problem, use this chart before calling for service.
Before Calling for Service
A102_01(E) 05.4.18 9:06 AM Page 26