Operation Manual

Now you are ready for sales registration.

Starting sales entries

This is not factory preset. You must enable this function.

• Foreign currency conversion rate

You must set a conversion rate to use

key.

• Preset unit price for departments

• Preset amount for

• Preset rates for

You do not have to program these preset prices/amount/rates since they can be entered at

registration. It might be convenient to preset so you do not have to re-enter every time.

• Amount entry digit limit for PO amount, RA amount, Manual tax amount

The factory setting makes the maximum amount you can enter. You can program to limit the amount.

• Sentinel - High amount lockout (HALO) for cash in drawer (CID)

• Department group

You can classify departments into a maximum of 9 groups (0 to 9 groups: 0: non-group is assigned).

Sales in each group can later be printed on an individual group total report and full group total report.

• Commission

If you program commission rates (up to two) and classify departments and PLUs/subdepartments into

commission groups (0 to 2 groups: 0: non-commission), commission sales and amount in each

commission group can later be printed on individual and full clerk reports.

• Key sequence for AUTO key

• RS-232C programming

• Specification of clerk to be trained

Department programming:

The cash register is pre-programmed for departments as follows:

Department: Allow open price entry in normal department (group: 0, commission group: 0), taxable status-

taxable 1 for department 1 to 6, and non taxable for department 7 to 99

When you use department 7 or above, and/or you apply taxable status other than taxable 1 for department 1 to

6, you must change department settings. Please refer to the department programming section for programming

details.

PLU/subdepartment programming:

The cash register is preprogrammed for PLUs/subdepartments as follows:

PLU/subdepartment selection: PLU is selected for all PLU codes so that you only have to program unit prices

and associated departments for them (by default, unit price is set to 0 and associated department is set to

department 1). Function parameters including tax status depend on the status of associated department.

• For direct PLU keys, PLU codes 1 through 75 are assigned for PLU 1 through 75 keys respectively.