Installation manual

Projector Driver Application Note
Sharp XG-E3000U
Revision B
DR-SHP19 - 10/19/01 SP Controls reserves the right to modify specifications without notice at any time.
This document describes the
SmartPanel
Projector Driver for the
Sharp XG-E3000U
projector. For more
information on configuring and using the Panel see the
SmartPanel Configuration and Installation Manual.
I. PROJECTOR CONTROL
A. Volume and Power Control
Volume control on the Sharp is
absolute
.
B. Input Selection Mapping
The following table specifies the factory-preset input mapping for this Driver. The
Configuration Utility
can be used to customize these settings your installation.
Selection 1:
VIDEO 1
Selection 2:
VIDEO 2
Selection 3:
RGB 1
Selection 4:
RGB 2
Input choices available for the Sharp with this
Driver are VIDEO 1, VIDEO 2, RGB 1 and RGB 2.
C. Hidden Function Mapping
The following table specifies the factory preset hidden function mapping for this Driver. The
Configuration Utility
can be used to customize these settings your installation.
Selection 1:
LENS SELECT
Selection 2:
ENTER
Selection 3:
ADJUST LEFT
Selection 4:
ADJUST RIGHT
Off:
MENU
Volume Up:
ADJUST UP
Volume Down:
ADJUST DOWN
Hidden functions names are based on the Sharp
remote and controls on top of the projector.
Adjust
controls navigate through onscreen menus. Hidden
functions are accessed by pressing the indicated key while the holding the
On
key down.
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
LENS SELECT
LENS FOCUS +
LENS FOCUS -
LENS ZOOM +
LENS ZOOM -
Projector
Ready
Warm-up
OFF
OFFOFF
OFF
ON
ONON
ON
Volume
VIDEO 1
VIDEO 2
RGB 1 RGB 2
Projector
Ready
Warm-up
OFF
OFFOFF
OFF
ON
ONON
ON
Volume
ADJUST
UP
ADJUST
DOWN
MENU
LENS
SELECT
ENTER
ADJUST
LEFT
ADJUST
RIGHT

Summary of content (5 pages)