User Manual

ManualsBrandsSharp ManualsStereo SystemXL-35H

MODEL

XL-35H

MICRO COMPONENT SYSTEM

0101

Accessories

Remote control battery installation

1 Remove the battery cover.

2 Insert the batteries as shown.

3 Replace the cover.

Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).

Batteries are not included.

FM/AM loop aerial 1AC power lead 1 Remote control 1

If you require any advice or assistance regarding

your Sharp product, please visit our web-site

www.sharp.co.uk/customersupport.

Customers without Internet access may telephone

08705 274277 during office hours (or (01) 676 0648

if telephoning from Ireland).

This Quick Start Guide will help you to correctly install and

operate your system.

– 1 –

TINSE0111SJZZ

02J N YT 1

Summary of content (4 pages)

PAGE 1
2 Remote control battery installation Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included. MODEL MICRO COMPONENT SYSTEM XL-35H 1 Remove the battery cover. This Quick Start Guide will help you to correctly install and operate your system. If you require any advice or assistance regarding your Sharp product, please visit our web-site www.sharp.co.uk/customersupport.
PAGE 2
3 System connections FM aerial AM loop aerial TV VCR, DVD, etc. Right speaker Left speaker To the line output sockets RCA lead (not supplied) 4 Turn on your system Wall socket (AC 230 V, 50 Hz) Press the ON/STAND-BY button to turn the power on.
PAGE 3
Listening to the radio Listening to a CD PUSH CLOSE 1 Press the FUNCTION button until “CD STOP” appears on the display. 2 3 Press the CD EJECT button to open the CD compartment. Place a CD on the spindle, label side up. 1 Press the FUNCTION button until “FM” or “AM” appears on the display. 2 Press the TUNING ( tion. or ) button to tune in to the desired sta- When the TUNING button is pressed for more than 0.
PAGE 4
Listening to a cassette tape Clearing all the memory (reset) 1 Press the ON/STAND-BY button to enter the power stand-by mode. 2 Unplug the AC power lead from the AC INPUT socket on the unit. 3 Whilst pressing down the MEMORY/SET button and the button, plug the AC power lead into the AC INPUT socket on the unit. PUSH EJECT Caution: 1 2 AC INPUT This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.