Specifications

04/1/28 XL-DH320N 350H_09 EN.fm
E-14
9
8
7
6
5
4
3
2
1
Listening to the radio
Auto power on function:
When you press any of the following buttons, the unit turns on.
●
TUNER (BAND) button (remote control only): The unit turns on
and the “TUNER” function is activated.
● / button on the main unit: The unit turns on and playback of
the last function starts (CD, TUNER, AUDIO IN, USB, iPod).
Notes:
●
When radio interference occurs, auto scan tuning may stop
automatically at that point.
●
Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING ( or ) button again.
●
When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator will
light up. Finally, the station name will appear.
●
Full auto tuning can be achieved for RDS stations “ASPM”, see
page 17.
To receive an FM stereo transmission:
●
Press the TUNER (BAND) button to select stereo mode and “ST”
indicator will be displayed. “ ” will appear when an FM
broadcast is in stereo.
●
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the “ST” indicator. The reception changes to
monaural, and the sound becomes clearer.
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become
disconnected.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
The stations saved in the memory can be scanned automatically.
(Preset memory scan)
■ Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING ( or ) button on the remote control to tune
in to the desired station.
●
Manual tuning:
Press the TUNING ( or ) button repeatedly to tune in to
the desired station.
●
Auto tuning:
When the TUNING ( or ) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
CD
USB
■ Memorising a station
1
Perform steps 1 - 3 in “Tuning”.
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button to select
the preset channel number. Store the stations in memory, in order,
starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory. If the “MEMORY” and preset number indicators
disappear before the station is memorised, repeat the operation
from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset
station. When a new station is stored in the memory, the station
previously memorised for that preset channel number will be
erased.
■ To recall a memorised station
■ To scan the preset stations
1
Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the desired
station is located.
■ To erase entire preset memory
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Whilst pressing down the FUNCTION button, press the
ON/STAND-BY button until “TUNER CLEAR” appears.