Specifications

E-27
ENGLISH
XL-E2H
Advanced Features
Enhancing your system
 Headphones
z Before plugging in or unplugging the headphones, reduce the
volume.
z Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended imped-
ance is 32 ohms.
z Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
z Do not turn the volume on to full at switch on and listen to music
at moderate levels. Excessive sound pressure from earphones
and headphones can cause hearing loss.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
 General
 CD player
Symptom Possible cause
z The clock is not set to the
correct time.
z Did a power failure occur? Reset
the clock. (Refer to page 10)
z When a button is pressed,
the unit does not respond.
z Set the unit to the power stand-
by mode and then turn it back on.
z If the unit still malfunctions, reset
it. (Refer to page 28)
z No sound is heard. z Is the volume level set to "0"?
z Are the headphones connected?
z Are the speaker wires discon-
nected?
Symptom Possible cause
z Playback does not start. z Is the disc loaded upside down?
z Playback stops in the
middle or is not performed
properly.
z Does the disc satisfy the
standards?
z Is the disc distorted or
scratched?
z Playback sounds are
skipped, or stopped in the
middle of a track.
z Is the unit located near excessive
vibrations?
z Is the disc very dirty?
z Has condensation formed inside
the unit?