Installation guide

KINO-6612 Mini-ITX Motherboard
Page 85
Table 5-1: Jumpers
5.5.1 Clear CMOS Jumper
Jumper Label:
J4
Jumper Type:
3-pin header
Jumper Settings:
See
830H832HTable 5-2
Jumper Location:
See
831H833HFigure 5-8
If the KINO-6612 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
 Enter the correct CMOS setting
 Load Optimal Defaults
 Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
832H834HTable 5-2.
AT Power Select Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 5-2: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in 833H835HFigure 5-8 below.